Price: ₹ 969.00 - ₹ 569.00
(as of Nov 07,2020 22:38:22 UTC – Details)



Wiring: (1) start-up board: red line V + then positive power source, black line V-then negative power supply, and then the antenna; (2) receiver board: the black line connected to the power supply is negative, the red line connected to the power supply is positive; R and L then motor, B and F line then motor. Band F output voltage more. (L)X(W): 5.7X3.8cm/2.24″X1.5″(appr.) Receiver Board Size:(L)X(W): 4.3X2.6cm/1.69″X1.02″(appr.) Features Brand New and high quality. Made of plastic and electronic Components material, durable and long life service. Suitable for toy model, remote control car, remote control boat. Can be used to control the direction of movement of the toy car like going forward or backwards. Attention: only can use small power motor, such as 130 motors, high power motor can burn the board. Notice: Please allow 1-3mm error due to manual measurement and make sure you do not mind before ordering. Please understand that colours may exist chromatic aberration as the different placement of pictures. Package Included: 2 x 4CH Board (with screws accessories) 4 lines,2v-3.5v Receiving range about 10meter Connection method: Emission Plate: red V+ positive power supply, black wire V- negative power supply, ANT connect the antenna

The RC transmitter is designed with a Dimensions: pad 3.5 * 7 cm, receiving plate 2.6 * 4.3 cm;
The remote control distance of the RC transmitter and receiver, in the case of adequate electricity, without interference, the correct access to the antenna after about 10 m, above only for reference.
To improve the senitivity of the rc remote control transmitter, please give the motor with a fire condenser.
The output of the two rc transmitter voltages can be the size of the difference, when the battery power may be more obvious, it is recommended to take a little voltage alone to make with the steering engine

LEAVE A REPLY

Please enter your comment!
Please enter your name here